OzVMX

The home of Aussie Vintage Motocross

April 2014 Blog Posts (3)

Anyone have any success salvaging an old rusted Bultaco motor.  The project is a very early Model 3 or newer 4 speed engine, with the external oil seal on the drive chain out put sprocket.  I am not …

Anyone have any success salvaging an old rusted Bultaco motor.  The project is a very early Model 3 or newer 4 speed engine, with the external oil seal on the drive chain out put sprocket.  I am not interested in saving the studs and logs nor most of the internals, but all fasteners are extremely rusted and Penetrating oil, heat and ATF have not been sufficiently helpful..  I just need to save the castings and some major components of the internals.  But this 'sucker" is locked up and every…

Continue

Added by John Popio on April 23, 2014 at 5:55am — 1 Comment

Carb woes ...

Today my VM32 carb was certified as deceased ... and so I need to buy a new one. It is for a Suzuki TM250 (1973). Is it worthwhile going to the VM34 ... if so, what would be the jetting / setting suggestions? It has the standard pipe (no silencer add on) ... and a unifilter foam air filter.

Any help / suggestions greatly received and appreciated.

Allan.

Added by ali swift on April 18, 2014 at 5:27pm — No Comments

Howdy!

Good day! I am a new member from the Southwest corner of Washington State, USA and am more than fond of vintage Yamaha Enduros, Hodakas, and street legal Mini's. I also operate a vintage bike website at www.Yamaha-Enduros.com dedicated to, of course, Enduros, as well as I am a webmaster at www.HodakaClub.org.

Added by Makotosun on April 14, 2014 at 6:31pm — No Comments

© 2019   Created by Graeme M.   Powered by

Badges  |  Report an Issue  |  Terms of Service